0 items - $0.00

HD Acid PL-10 Original

$160.76

SKU: 6013 Categories: ,

PL-10 is a concentrated liquid low foaming acid detergent which helps prevent and remove milkstone and mineral deposits from equipment surfaces.

Properties:

Form …………………………………………. Liquid
Color …………………………………………. Red
Odor …………………………………………. Faint odor
Foam ………………………………………… Low
Spec. Grav. @ 68ºF (20ºC) …………. 1.222
100% solution pH ………………………. 1.0
Formula ingredients contain not more than 11.1% phosphorus, 1.93 grams per liter of average recommended use concentrations.

Cleaning Pipelines

  1. Pre-flush pipelines and milking units with large volume of potable water.
  2. Prepare wash solution using proper use dilution of an appropriate chlorinated alkaline cleaner, following label directions carefully.
  3. Circulate wash solution through system for 8-10 minutes. Brush-wash all parts not coming in contact with the wash solution. Wear impervious gloves when brush-washing equipment.
  4. Rinse with large volume of potable water to remove all wash solution. Allow to drain.
  5. Finish with acidified water rinse. Add 1 fl oz/10 Gal of HD Acid PL-10 per Liter of potable water. Rinse system and allow to drain.
  6. Just before milking (no sooner than 30 minutes), sanitize by circulating proper ppm solution of a recommended sanitizer. Drain completely.

Cleaning Bulk Tanks

  1. Pre-flush bulk tank with large volume of potable water.
  2. Prepare wash solution in volume necessary to properly operate the spray device, using proper use dilution chlorinated alkaline cleaner following label directions carefully.
  3. Spray-Wash for 8-10 minutes. Disconnect return line and drain. Inspect all milk zone surfaces for cleanliness. Prepare was solution using 30 gms of a chlorinated manual cleaner per 1 liter of hot water(4 US oz/US Gal). Brush-wash valve outside of tank and any part of tank not cleaned by spraying system. Wear impervious gloves when brush-washing equipment.
  4. Rinse inside and outside of bulk tank with potable water to remove all wash solution. Allow to drain.
  5. See steps 5 and 6 above.

*Where local or state regulations are in effect, consult authorities for additional information.

NOTE: HD Acid PL-10 is not a sanitizer. Avoid food contamination during application and storage. Do not store in food processing areas. Rinse surfaces thoroughly with potable water after use. This product is not for use as hard surface disinfectant or sanitizer. Consult your Ecolab representative for specific use instructions and recommended dispensing equipment.