0 items - $0.00

Super-Klenz 45#

$86.56

#6081

Super-Klenz™ is a chlorinated, high alkaline powdered detergent, especially for bulk tank and pipeline washing.

SKU: 6081 Categories: ,

Properties

Form…………………………powder
Color……………………………white
Odor……………….slight chlorine
Foam………………………………low
Contains 3.1% Chlorine
1.0% pH………………………….12.5
0.1% pH………………………….12.0
Alkalinity:
Active as Na2O………………39.1%
Total as Na2O……………….54.3%
Formula ingredients contain not more than 2.8% phosphorus, 0.5 g per gallon of average recommended use concentration.

Benefits

Promotes Quality Assurance

  • Heavy duty chlorinated formula rapidly removes protein soils.
  • Low foaming formulation provides more efficient CIP cleaning.
  • Caustic based formulation works at lower drop temperatures.
  • Especially designed to leave three-inch systems spot-free and smelling fresh.

Saves Money

  • Stable powdered formulation gives longer shelf life.
  • One step circulation cleaner – no chlorine or water conditioning additives required.

Directions

Cleaning Pipelines:

  1. Pre-flush pipeline and milking units with large volume of warm (100°F/38°C –110°F/43°C.) tap water.
  2. Prepare cleaning solution using 1 oz. of Super-KlenzTM to each 3 gallons of hot water. (Starting temperature 160°F/71°C.) (Do not guess at amount of water. Measure and put mark on tank.)
  3. Circulate cleaning solution through system for not more than 8 minutes. Using 4 oz. of a chlorinated manual cleaner and not more than 3 or 4 quarts (30 g/L) of hot water, brush-wash all parts not cleaned by mechanical system. Wear impervious gloves when brush-washing equipment.
  4. Rinse with a large volume of potable water to remove all detergent solution. Follow with proper use dilution of MandateTM Plus to acid rinse and sanitize in one easy step. Or use proper use dilution of a pipeline acid.
  5. Unless MandateTM Plus was used to acid rinse and sanitize in last step, just before milking, sanitize by circulating proper ppm solution of EPA registered sanitizer, following label directions. (Do not sanitize more than 30 minutes before using equipment.) Drain completely.

Note: When step 4 is followed, alternate acid cleaning with recommended acid detergent is not necessary. The acidified rinse prevents formation of milkstone, mineral deposits and leaves surfaces film-free.

Cleaning Transfer Systems:

Fill receiver container with enough hot water to establish recirculation. Add 1 oz. ofSuper-KlenzTM per each 2.5 gallons of 160°F/71°C. water. Follow pipeline cleaning procedure.

Mechanical Cleaning of Bulk Tanks:

  1. Pre-flush tank with large volume of warm (100°F/38°C – 110°F/43°C.) potable water.
  2. Prepare washing solution in plastic pail using 1 ounce of Super-KlenzTM to each2 gallons (3.8 m/L) of hot water (160°F/71°C).
  3. Allow to circulate for not more than 8 minutes. Disconnect return line and drain.
  4. Inspect all milk zone surfaces for cleanliness. Prepare concentrated washing solution using 4 oz. of a chlorinated manual cleaner and not more than 3 or 4 quarts (30 g/L) hot water (160°F/71°C). Brush-wash valve outside of tank and any part of tank not cleaned by mechanical system. Wear impervious gloves when brush-washing equipment.
  5. Rinse tank thoroughly inside and out with clear water. Follow with proper use dilution of MandateTM Plus to acid rinse and sanitize in one easy step. Or use proper use dilution of a pipeline acid. Circulate. Allow to drain.
  6. Unless MandateTM Plus was used to acid rinse and sanitize in last step, just before milking, sanitize with proper ppm solution of EPA registered sanitizer. Allow tank to drain before closing valve.