Properties

Form………………………….. liquid
Color……………………light yellow
Odor……………….slight chlorine
Foam…………………………….none
Specific gravity @ 68° F.1.237
Contains 2.8% Chlorine
pH (1.0% solution)………….12.3
(0.1% solution)………………..11.1
Alkalinity:
Active as Na20…………….12.2%
Total as Na20……………….14.0%
Weight/gal.10.30 lbs. 4.67 kg.

Formula ingredients contain not more than 0.01%phosphorus, 0.02 g per gallon of average recommended use concentration.

Benefits

• Prevents burning of stainless steel by undissolved powders.
• No white films – leaves stainless steel bright and shiny.
• Works in systems that cannot tolerate foam.
• Easily dispensed – no complicated mixing equipment.
• Excellent solubility – no undissolved residues.
• Non-corrosive to 304 and 316 stainless steel when used at recommended dilutions.
• Chlorinated formula attacks and removes protein soils.
• Leaves equipment spot-free.
• Low foaming formulation.
• Contains chlorine and water conditioning agents.
• Labor savings – no mixing or dissolving required; no additives required.

Directions

Use Dilutions – Cleaning Pipeline Milkers

0-18 grains hardness – 1 oz. per each 3 gallons (2.6 mL/L) hot water (160°F./71°C.).
18-40 grains hardness –1 oz. per each 2 gallons (3.9 mL/L) hot water (160°F./71°C.).

1. Pre-rinse system thoroughly with potable warm water (100°F./38°C. – 110°F./43°C.).
2. Prepare washing solution using the correct dilution as recommended above.
3. Circulate cleaning solution through system for not more than 10 minutes. Temperature must not go below 100°F./38°C. during wash cycle.4
4. Rinse system thoroughly with 1 ounce of Mandate Plus to each 6 gallons (1.3 m/L) rinse water to acid rinse and sanitize in one easy step. Or follow with an acidified rinse using the proper use dilution of PL-10 or Envirocid Plus and warm water (100°F./38°C. – 110°F./43°C.).
5. Unless Mandate Plus was used to acid rinse and sanitize in the last step, just before milking, sanitize by using proper use dilution of Equipment Sanitizer and water. (Do not sanitize equipment sooner than 30 minutes before use.)

Use Dilutions – Cleaning Bulk Tanks

0-18 grains hardness – 1 oz. per each 2 gallons (3.9 mL/L) hot water (160°F./71°C.).
18-40 grains hardness – 1 oz. per each gallon (7.8 mL/L) hot water (160°F./71°C.).

1. Pre-rinse bulk tank with potable, warm water (100°F./38°C. – 110°F./43°C.).\
2. Prepare washing solution using the correct use dilution as recommended above.
3. Circulate and spray solution on bulk tank surfaces with mechanical washing unit for not more than 10 minutes. Temperature must not go below 100°F./38°C. during wash cycle. Drain.
4. Rinse inside and outside of bulk tank with proper use dilution of Mandate Plus to acid rinse and sanitize in one easy step. Or follow with an acidified rinse using the proper use dilution of PL-10 or Envirocid Plus. Circulate. Allow to drain.
5. Unless Mandate Plus was used to acid rinse and sanitize in the last step, just before milking, sanitize by using proper use dilution of Equipment Sanitizer and water. (Do not sanitize equipment sooner than 30 minutes before use.)