Properties
Form…………………………………………liquid
Color…………………………………………….red
Odor…………………………………slight nitric
Spec.Grav.@ 68°F(20°C) …………….1.176
lbs per gal………………………….9.8 (4.4 kg)
pH 1% solution………………………………1.3
Acidity calculated as Nitric Acid….32.8%
Formula ingredients contain not more than 3.3% phosphorus, 1.0g per gallon of average recommended use concentrations.
Benefits
Promotes Quality Assurance
- Leaves equipment shiny and film-free.
- Low-foam formulation promotes free-rinsing.
Directions
Cleaning Pipelines:
- Pre-flush pipelines and milking units with large volume of potable water.
- Prepare wash solution using proper use dilution of an appropriate chlorinated alkaline cleaner following label directions carefully.
- Circulate wash solution through system for 8-10 minutes. Brush-wash all parts not coming in contact with the wash solution. Wear impervious gloves when brush-washing equipment.
- Rinse with large volume of potable water to remove all wash solution. Allow to drain.
- Finish with acidified water rinse. Add one (1) ounce of HD PL-10TM Plus to each 10 gallons (0.78 mL/L) of potable water. Rinse system and allow to drain.
- Just before milking (no sooner than 30 minutes), sanitize by circulating proper ppm solution of an appropriate EPA-registered sanitizer. Drain completely.
Cleaning Bulk Tanks:
- Pre-flush bulk tank with large volume of potable water.
- Prepare wash solution in volume necessary to properly operate the spray device, using proper use dilution of an appropriate chlorinated alkaline cleaner following label directions carefully.
- Spray-wash for 8-10 minutes. Disconnect return line and drain. Inspect all milk zone surfaces for cleanliness. Prepare wash solution using 4 ounces of a chlorinated manual cleaner and not more than 1 gallon of hot water. Brush-wash valve, outside of tank and any part of tank not cleaned by spraying system. Wear impervious gloves when brush-washing equipment.
- Rinse inside and outside of bulk tank with potable water to remove all wash solution. Allow to drain.
- Finish with acidified water rinse. Add one (1) ounce of HD PL-10TM Plus to each 10 gallons (0.78 mL/L) of potable water. Rinse system and allow to drain.
- Just before milking (no sooner than 30 minutes), sanitize by circulating proper ppm solution of an appropriate EPA-registered sanitizer. Drain completely.