1 item - $169.89

HD PL-10 Plus

$17.75$726.97

HD PL-10™ Plus is a concentrated, non-foaming, tri-blend detergent, which helps remove alkaline films from milking equipment surfaces.

SKU: N/A Categories: ,

Properties

Form…………………………………………liquid
Color…………………………………………….red
Odor…………………………………slight nitric
Spec.Grav.@ 68°F(20°C) …………….1.176
lbs per gal………………………….9.8 (4.4 kg)
pH 1% solution………………………………1.3
Acidity calculated as Nitric Acid….32.8%
Formula ingredients contain not more than 3.3% phosphorus, 1.0g per gallon of average recommended use concentrations.

Benefits

Promotes Quality Assurance

  • Leaves equipment shiny and film-free.
  • Low-foam formulation promotes free-rinsing.

Directions

Cleaning Pipelines:

  1. Pre-flush pipelines and milking units with large volume of potable water.
  2. Prepare wash solution using proper use dilution of an appropriate chlorinated alkaline cleaner following label directions carefully.
  3. Circulate wash solution through system for 8-10 minutes. Brush-wash all parts not coming in contact with the wash solution. Wear impervious gloves when brush-washing equipment.
  4. Rinse with large volume of potable water to remove all wash solution. Allow to drain.
  5. Finish with acidified water rinse. Add one (1) ounce of HD PL-10TM Plus to each 10 gallons (0.78 mL/L) of potable water. Rinse system and allow to drain.
  6. Just before milking (no sooner than 30 minutes), sanitize by circulating proper ppm solution of an appropriate EPA-registered sanitizer. Drain completely.

Cleaning Bulk Tanks:

  1. Pre-flush bulk tank with large volume of potable water.
  2. Prepare wash solution in volume necessary to properly operate the spray device, using proper use dilution of an appropriate chlorinated alkaline cleaner following label directions carefully.
  3. Spray-wash for 8-10 minutes. Disconnect return line and drain. Inspect all milk zone surfaces for cleanliness. Prepare wash solution using 4 ounces of a chlorinated manual cleaner and not more than 1 gallon of hot water. Brush-wash valve, outside of tank and any part of tank not cleaned by spraying system. Wear impervious gloves when brush-washing equipment.
  4. Rinse inside and outside of bulk tank with potable water to remove all wash solution. Allow to drain.
  5. Finish with acidified water rinse. Add one (1) ounce of HD PL-10TM Plus to each 10 gallons (0.78 mL/L) of potable water. Rinse system and allow to drain.
  6. Just before milking (no sooner than 30 minutes), sanitize by circulating proper ppm solution of an appropriate EPA-registered sanitizer. Drain completely.